Share this content on Facebook!
21 Sep 2015
Supplies required for making the string bracelet:
- Golden Spacer Bead
- Crimp Bead
- Lobster Claw Clasp
- 0.5mm Tiger Tail Wire
- 1mm Nylon Thread
- Flat Nose Plier
- Scissors

Step1: Increase the risk for spacer bead strand
1st, cut a 50cm long wire and connect a crimp bead at 5cm through the end;
2nd, slide the spacer bead one after one;
3rd, stop in the event the beads strand almost twice the duration of your wrist circumference;
4th, attach another crimp bead at end to prevent beads from dropping and adjusting the tightness among beads on wire.

Step2: Wrap on the string
1st, cut a length of 1mm nylon thread, measuring about 100cm;
2nd, fold it by 50 percent;
3rd, fold you beaded strand as picture shows and loop the thread round the area between first couple of beads. Bring one end going over the beaded strand and yet another one going under;
4th, twist two ends together to turn the cord in opposite direction. Angling down to the following gap and do it again above; handmade

5th, continue crossing over and filling out the gaps;
6th, eliminate the two crimp beads at ends and tie both the ends of tiger tail wire;
7th, secure two thread end using a tight knot. Ensure and then trim off any excess thread.

Step3: Attach the clasp
Open the jumprings and connect the clasp at end!
So, there you’ve your new string bracelet!
Wire Wrap Jewelry


Comments

There isn't any comment in this page yet!

Do you want to be the first commenter?


New Comment

Full Name:
E-Mail Address:
Your website (if exists):
Your Comment:
Security code: